crank balancing?

scbird1

Registered User
Dose this crank look like its been rebalanced? It looks like a lot more holes were drilled. I not sure if im luckey to find a new crank,bearings,rods and pistons. After all I pulled the motor not knowing what was done to it but the heads were off and I didnt want to pull it again. At least I know whats what. I still checked all oil and ring clearances.
 

Attachments

  • picture 050.jpg
    picture 050.jpg
    62.5 KB · Views: 85
It's hard to say for sure, but I know Ford never painted the blocks red. So it's at least been apart before.

Look on the back of the bearings. If it's original, the bearings will have Ford PN's on them. Also, most all bearing manufacturers put a date on the bearings, so you can figure about when it was rebuilt.
 
Back
Top