porting 89 supercharger

[Hector Davila]

Hi fella's , i just took apart my sc to replace bearings and seal . I read a feu posts about porting but difrent guys had doneit defrent ways and i don't know wich way to do it. Can some one email me and give me an idea on how to get it done with out going too far . anybody that can help please ? . Thanks verymuch. email add. hgdavila@aol.com

[aplvlydrtybird]

go to magnum powers' wesite, they are the most common porting services, or you can go to www.supercoupeperformance.com and they have the same thing done through them...but that is the way i will eventually go, make sure you have some mods done before you put a ported supercharger on...good luck

[Hector Davila]

Thanks for the reply , i have new performance exaust coming and few other mods. I'll give it a try . Thanks again Keith.:)

[aplvlydrtybird]

good deal, the exhaust is the main thing to do, if its on an 89 sc with some miles....you might be doing head gaskets...unless they were already done...good luck

[Hector Davila]

I don't know if thy've been done but the car has 135plus miles i think i'd beter throw a set of head gaskets before i mount everything alse on. Thanks for the reply guys.

[aplvlydrtybird]

if ya havent done this before, make sure you read up or look at a good book about it. remember dont reuse the head bolts get new ones.

[Hector Davila]

Hey keyth, do you know wich type of head gasket would be best to buy ?, i heard felpro but there may be some beter ones . Also where can i get the head bolts . Thanks!.