Help Asap Power Steering

Back n black bird

Registered User
Ok i sprung a leak in my power steering somewhere, i had some mechanic find where it was coming from, and its the high pressure hose, anyway i took off the IC tube and now looking at the pump where the electronic connector goes that piece can swivel and is a little loose, is this where its leaking from? Or is there suposed to be play in that area. Its also sloppy where the high pressure line goes into the pump, like i can move the line around by hand. Is this right? or should that all be tight? Thanks guys. Also any how-toos on removing this line?
 
i would recommend u drain all the power steering and just replace the lines. My SC did that and it was a mess... but i replaced the lines and all is better now.
 
Find out if the line rubbed on something and wore a hole. Bad motor mounts allow the engine to sit too low and this can happen.

Jerry
 
Back
Top