Temp gauge

catwithboost

Registered User
I have a after market temp gauge. Can I just cut and splice into the ex. sender unit? The sender unit that came with the new gauge is like 2" long to go into the ex. temp hole.
 
It depends on which gauge you have. Some might work with the stock sending unit.

I bought a Cyberdyne gauge and I tried to hook it up to the stock sensor and the readings were way off.

You can try to use it with the stock sending unit and if not, I'm sure you can mix and match some fittings to allow you to use the aftermarket sender.
 
Splice into the wire on the top of the sending unit and hook up your gauge rougly under the hood. Let the engine heat up and see if it starts to work as normal.
 
Back
Top