BBK 75bb and TPS volt.?

joenintiesc

Registered User
BBK 75mm tb and TPS volt.?

I have the BBK 75 tb. I drilled out the holes on the TPS. Even after "adjusting it" as much as I can, and attaching the throttle cable and setting the idle stop screw, the best I can get the tps voltage to read is .67 at rest.

Is this ok, or should I be doing something else?

Thanks...
 
Last edited:
is the voltage going up steadily as you open the throttle
and max out near 5.0 volts?
if so you should be fine
 
The voltage increases as it should. But the beginning voltage is supposed to read around .95 volts. I'd like to find out if the lower reading may be the cause of my low/stalling idle problems at start-up...
 
Back
Top