driveshaft

luznit

luznit

Registered User
Anybody know which one is the direct bolt on aluminum driveshaft?Mark VII or Mark VIII?Thank's in advance.
 
Last edited:
I think it is a 93 mark 8. 93 is the only 1 piece al driveshaft. Better check tccoa.com to be sure though
 
So what kind of SC are you going to build around that 93 MarkVIII drive shaft? What did CeeGees do with the 1 they had? Good luck
 
Hi Jerome,
That's the one i'm getting,i just want to make sure it's the right one so i don't have to cut it and have it balanced at Green's.
 
The 93 Mark VIII was the only one that was a one piece. Ive just bought 2 one for my 4.6L and my SC. Ive got one out of a 94 but its the 2 piece one.
 
To use the Mark Viii DS, it's lenght is too short for AOD's and too long for 5-speeds.

From the SC FAQ: http://www.sccoa.com/forums/showthread.php?t=12757

89-95 5spds: 53 1/2"
89-93 AOD: 57 7/8"
94-95 4R70W: 57

The Mark VIII DS is 56.75 . So it should work fine for 94-95 SC's with 4r70w. But for an AOD SC, you will need a spacer, I believe Steeda makes one.
 
You must log in or register to reply here.
Back
Top