fastsc92
Registered User
OK, i'm not going to build the motor now, but in the future i plan to make it as strong as possible. I'm pushings close to 380hp at the crank, all on a stock bottom end thats making my cringe just thinking about it. I've done a search and havent really found the info i was looking for. Here are my questions
I can just buy a set of 351 h-beam rods? Pressed pin or bushed pin?
Are they 351W(5.956") or 351C(5.780") rods?
Can i get a rod bearing set for a 351 and will it work ok?
What info is needed for custom pistons to be made? Is there are Ross/diamond part number?
And why do custom pistons need to be made....is it something about the rod width or specs?
How much can I expect to pay for a set of pistons?
Rods i can find on ebay for about 250 for a set of 8.
I can just buy a set of 351 h-beam rods? Pressed pin or bushed pin?
Are they 351W(5.956") or 351C(5.780") rods?
Can i get a rod bearing set for a 351 and will it work ok?
What info is needed for custom pistons to be made? Is there are Ross/diamond part number?
And why do custom pistons need to be made....is it something about the rod width or specs?
How much can I expect to pay for a set of pistons?
Rods i can find on ebay for about 250 for a set of 8.
Last edited: