Man, has it been quiet here or what.

[Flip]

This has been a quiet group since the Daytona meet, anything going on? Anybody install any new goodies lately? Or is everyone just working and living? :D

[TbirdSC93]

I installed a new IC fan and power window motors....gonna get the cats taken off to when I have the chance since half the exhaust came back seperate from the car...also might upgrade the fuel pump too since the gas tank is about halfway out the car too

[Flip]

Anything going on with the tranny yet?

[TbirdSC93]

Waiting on a letter from the legal aid office whether or not there gonna take my case....more than likely tho Ill just have to go to small claims court...probably go for full refund and then sum...hopefully enough to get a lentech street terminator

[Gregthespy]

Hey Flip,
Yeah, I've been installing my I/C fan as well this Easter Sunday and been working a bunch as usual. I noticed that the forums were a bit quiet as well. I'm also waiting for my ported manifolds to arrive from Tbird88 which should be next week or so then I too will be bypassing my cats to connect to that Flowmaster cat back system. So I too am just about in the same boat as Jeremy minus the tranny issues. :rolleyes:
Late yesterday I swung by Mike Yates (lessonintorque) and swapped my bent bondoed trunk lid with his off of the donor SC as he pulled the engine for the Mustang swap. I hopefully by next week will be picking up the Centerforce clutch set as well and will install that when time permits for that large of a job.
But other than that not much has been happening around the house, which can be a good thing. :)

[XR7Kurt]

I've been trying to get my front end together, it has taken a while in between waiting for parts and waiting for money for parts. I'm just about ready to start putting it back together but have a couple questions and a couple more little parts.
I have new tires, an IC fan, and a resonator on the way.
Next weekend I'm heading to the Mustang 40th anniversary show in Nashville.
I've also been helping a friend look for a car. He ended up getting a 96' Trans Am so I have definate performance goals for my car!

[SuperChicken89]

Yea, I also noticed it has been quiet around here lately.
Been doing a little work to the SC since Daytona. Installed my SCI pulleys, realigned the hood, fixed a small leak in the radiator, and cleaned under the hood a little more. Next will be a 3/4" SC outlet install when it gets here. Other than that not much. I am considering pulling the heads this summer for a port and polish job along with new head gaskets and a match job on the exhaust manifolds and the intake. After that is complete next would be the larger MAF, TB, and higher volume fuel pump. And the list goes on and on and on...

Bryan

[Flip]

I think they got my car mixed up with yours on the front photo for SC of the month.


I don't think I mixed that up... Flips was on the left and Bryan's was on the right... I could tell the difference cause of the Snipers!!

RJ

[kamakazie_1]

Sorry Flip it let me edit your message... Usually it tells me you can't do that... I didn't mean to delete part of your post!!!

Sorry bout that!!

[Flip]

RJ, It must be those savvy “IS” skills that you have. :D

Original post went something like this:

Installed my rear air bags today, cured my tire problem and stopped almost all the wheel hop I think. Need a set of shocks big time.

Bryan, Man how can you get it any cleaner under the hood? You keep raising the bar…
As clean as your SC is, I think they got my car mixed up with yours on the front photo for SC of the month. :)

I also looking to get a ¾ top and double ic sometime also, like you said the list just goes on and on.

[kamakazie_1]

RJ, It must be those savvy “IS” skills that you have. :D


It was supposed to be a quote instead of edit.... They ought to make that edit button red after 10 at night!! What can you expect from me at 1AM!!

:D

RJ