kamakazie_1
Registered User
Good morning folks,
I was late last night installing the vane on the back of the HB or Vibration Dampner, I didn't notice the odd tooth design till after I pulled the vane off the OEM dampner.
It appears that the vane will only line up on the bolt holes one way, just slightly offset in 3 of the 4 positions. I just wanted to make sure that I didn't need to have that odd postioned tooth patern located on a certain place on the HB before I put all this back together.
Any input??
RJ
I was late last night installing the vane on the back of the HB or Vibration Dampner, I didn't notice the odd tooth design till after I pulled the vane off the OEM dampner.
It appears that the vane will only line up on the bolt holes one way, just slightly offset in 3 of the 4 positions. I just wanted to make sure that I didn't need to have that odd postioned tooth patern located on a certain place on the HB before I put all this back together.
Any input??
RJ