How do I check codes?

Well the code conversion is your ability to count.. you watch the needle on the voltmeter swing up/down.. or in your case, set the sampling rate (if you can) to fast as possible and the watch it run up/down and that equals 1 count. I find it easier to use the paper clip method, no volt meter required just count the blinks of the check engine light. This takes a couple of tries to get the hang of it.

Here's a couple of links for how-to:
http://dalidesign.com/hbook/eectest.html
http://www.corral.net/tech/maintenance/eecivtest.html
 
great I was looking for this too this weekend. I'm surprised it wasn't in the FAQ, and I had no luck with searching the forums either. Thanks!
 
Back
Top