Melon
SCCoA Member
So after the swap that was done with my car, one of the last things to be done is hook up the tach. After looking at some wiring diagrams in the Chilton's book and searching on here, I may have found the wire to 'tap' into. A wire has already been setup from the cluster for the tach - I just need to figure out where to put it. Here's what I'm thinking:
The engine is from a 90 SC - and the wire I'm thinking is a Yellow and Light green wire, on the passenger side of the DIS. According to the Chilton book, it goes from the DIS, to the test connector, and then to the electronic engine control module. Is that right?
Any help with this apperciated. Thanks
-Andy "Melon"
The engine is from a 90 SC - and the wire I'm thinking is a Yellow and Light green wire, on the passenger side of the DIS. According to the Chilton book, it goes from the DIS, to the test connector, and then to the electronic engine control module. Is that right?
Any help with this apperciated. Thanks
-Andy "Melon"
