Where to get steel idler pulleys

[V6Sprout]

I thought everyone got them at Canadian Tire, but when I called they said they don't list anythign for the Supercoupe idler. Anyone got a part number for them or where I can get them, my plastic ones are in rough shape.

[johnny o]

At Ford P/N YS-233 about $21 each
-3" cobra? part, reuse your old bolt, not quite wide enough but work

or Dayco offers a slightly wider pulley that you may also use
-Dayco 89005 2 7/8" stock supercharger idler size
-Dayco 89007 3" more tension for sc belt and stock replacement for other two

I personally use the 3" Ford ones and haven't had any problems with them. A lot of guys drill the washer on the new bolt out to the larger size of the stock SC bolt so they have a dust shield for the bearing but that's up to you. You might want to get 3 3" Dayco ones, I've never used them but if they are wider then this would be better.

[SeanMatteson]

I think there's a better version of the Dayco 3" pulley. It's not 89007. I've got a box from one at my place. I think it might be 89016, but Steve Richards may remember off-hand. I got the box from him when we installed them on his car. This is a 3" pulley that is wider than the 89007, or that has a better bearing position/offset in relation to the Super Coupe setup.

Best regards,

Sean

[Steve Richards]

Hi Jamie,
Canadian Tire does sell them. There are two sizes. The larger ones are harder to get since there are only 2 stores that have them and I don't think there are any in their warehouse. If they look under a 1989, none are listed since there is a problem with their database. I got them to look under a 1990 and spotted both codes. The second one listed is the larger one.

All the idler pulleys are the same size and I think it's listed under a/c idler or steering idler pulley.

Hope that helps.

[SeanMatteson]

...I'm guessing Steve and I were posting at the same time. :D

Cheers,

Sean

[Steve Richards]

Righto Sean

[SeanMatteson]

Just to be clear, Steve, does '89016' sound familiar to you too? I'm pretty sure that's the part number of the pulleys we put on your car.

Cheers,

Sean

[Steve Richards]

89016 is the correct one.

[Tazer999]

89016 are the ones i got from work yes and they are the right ones

[V6Sprout]

cool, thanks guys! I may just steal Steve Richards pullies since they are sitting right here, hahhahaha, just kidding steve!

[Steve Richards]

:eek: :( :confused: :) :p