Fel-Pro Head Gaskets install

ipeefreely

Registered User
I am going to install some Fel-Pro head gaskets that are a "Fiber Faced Gasket", on the sheet that came with then it says to "install dry". I was wondering if that means do not put anything on them when I install them or do I need to use a little RTV(or spray tack) on them or something? :confused:

Thanks,

Jay
 
hi

it means leave them alone because if you put somthing
i between it will change the thickness in diffrent areas and
it may not seal properly could cause major problems later

mike
 
Last edited:
put them on dry , and clean the head and block very good i used a stainless scrub bud for doing dishes that was 12k miles ago and running awesome , i also ported the exhaust ports with a dremel wow i wanna take them back off ang grind some more it helped so much
 
Back
Top