SC pulley nut torque?

Darkside

Registered User
Anybody know the torque value for the supercharger pulley nut? I'm not sure if it has a torque or it's just German torqued.
 
German torqued? If that means absurdly tight, I wouldn't. On mine, I just made it bout as tight as it was.. if that helps. Keep in mind that it is a tight fit to begin with and has a key way so the only thing the bolt does is sort of keep it in place. If I had to pick a number, I'd say 20-25 lbs.
 
hahah you guys crack me up :D im installing my 5% tomorrow too. then ill go lay down some rubber :eek: :D :cool:

(as if i dont do it enough already)
 
35 ft.lbs of torque is the answer and, use a little 'anti-sieze' on the shaft + a little 'loctite' on the threaded end.
 
If you are installing an aluminum pulley, DO NOT use any antiseize. Stock nut should not be used with loctite, aluminum nuts should.

Paul
 
Back
Top