Driveshaft swap?

DLF

Registered User
Got myself an aluminum driveshaft.

Does anyone know if dropping the pumpkin as far as the half-shafts will allow will provide enough clearance to pull the driveshaft yoke out of the transmission, and then slide the driveshaft forward to remove it from the car?
 
if you drop the rear end and let the half shaft sit on the subframe, you will have just enough room to pull the shaft back over the rear end and slide it forward.

Stephen
 
89SCK@t said:
if you drop the rear end and let the half shaft sit on the subframe, you will have just enough room to pull the shaft back over the rear end and slide it forward.

Stephen

Exactly what I was hoping to hear, thanks!
 
Back
Top