Code 19

ShawnSC1 said:
Can somebody help me out on this code I am geting.
Code 19 says Failure in Electronic Control Assembly (ECA)- problems with interal voltage regulater. or, RPM too low for EGR check during Engine Run Self-test. or,Cylinder identification (CID) sensor imput failure. Thats what my code book says. Search ECA would be a good start.and go from there. Good Luck!
 
Has anybody had this problem. It takes a little to get it going. When you finely get it going it runs great, then dies right down and stalls, unless you give it gas. With this code 19, can it be a simple sensor, or will I need a new EEC. Reson I am asking is because I want to use this EEC for my AOD to 5-speed swap.

I have no clue what the ECA or CID are..

Oh ya this car has been sitting for a couple of years, and has not run. Not sure if this could of caused the problem.
 
Back
Top