89_Red_Xr7
Registered User
Hello,
I am planning to swap out my transmission and fix my leaking rear main seal this weekend, and just had a quick couple of questions......
First off, the clutch/slave/bearings in the car right now only have around 15K miles on them. when I am ready to put the new trans. in the car, could/Should I reuse the pressure plate/slave cylinder/bearings ect..?? I'm not trying to do the job cheaply, but if they work, why buy new ones?
Secondly, what is the part number for the clutch disk? i cant seem to find it. On the FAQ part number listings, the 11.5" disk is listed. can i use the larger disc with my existing equipment?
Just trying to get everything figured out before I tackle this. Any other input would be appreciated!
Thanks!
Andrew
I am planning to swap out my transmission and fix my leaking rear main seal this weekend, and just had a quick couple of questions......
First off, the clutch/slave/bearings in the car right now only have around 15K miles on them. when I am ready to put the new trans. in the car, could/Should I reuse the pressure plate/slave cylinder/bearings ect..?? I'm not trying to do the job cheaply, but if they work, why buy new ones?
Secondly, what is the part number for the clutch disk? i cant seem to find it. On the FAQ part number listings, the 11.5" disk is listed. can i use the larger disc with my existing equipment?
Just trying to get everything figured out before I tackle this. Any other input would be appreciated!
Thanks!
Andrew