PDA

View Full Version : Can a stock pulley be turned bown to a 5%???



sizemoremk
08-19-2004, 10:57 AM
Is there any reason why I can't get my stock SC pulley turned down?

I have a good friend wth a lathe that says he could turn it down...

Isn't there plenty of material in there to work with?

Conan56
08-19-2004, 11:33 AM
The factory pulley is hollow inside I dont think you have enough material to turn it down (If Im wrong feel free to correct me)
Why bother You can get 5% or 10% for anywhere from 45.00-75.00

Id ont even worth your time trying to turn it down

Ryan A Harris
08-19-2004, 12:30 PM
You're buddy should be able to take the measurements, and then tell you if it can be turned down to a 5%. Just make sure to make the grooves deeper as well, the belt may slip on the pulley if that isn't done propperly.