I just got a new engine installed along with some mods: I have a 94 SC 5speed.
ESM ported Supercharger 94/95 Case
MP 3/4 Top
75MM TB
75MM Pro-M Maf for 36 lbs (stock) injectors*
Apten Chip
180 T-Stat
Now the check engine light did not go on until I installed the chip. The car will run fine and it seems after running for a while or when getting hot, the check engine light comes on and it idles a little rough. The chip was programmed for the Maf and the TStat and the mods that matter. When I recieved the flow sheet with the Maf it said 89TBird. Could this be the problem?? I called Bill at SCP where I ordered the Maf and he said it shouldn't be a problem. Is there anything that I should do to reset the computer at all?? I disconnected the battery for the chip install and also pulled the fuse for the ECU in the engine compartment. Thanks guys.
Drew
ESM ported Supercharger 94/95 Case
MP 3/4 Top
75MM TB
75MM Pro-M Maf for 36 lbs (stock) injectors*
Apten Chip
180 T-Stat
Now the check engine light did not go on until I installed the chip. The car will run fine and it seems after running for a while or when getting hot, the check engine light comes on and it idles a little rough. The chip was programmed for the Maf and the TStat and the mods that matter. When I recieved the flow sheet with the Maf it said 89TBird. Could this be the problem?? I called Bill at SCP where I ordered the Maf and he said it shouldn't be a problem. Is there anything that I should do to reset the computer at all?? I disconnected the battery for the chip install and also pulled the fuse for the ECU in the engine compartment. Thanks guys.
Drew