Slam Hood and immediately runs rough???

Parker Dean

Registered User
This afternoon I had the hood up with the engine running and it was idling fine. I drop the hood and immediately it began to run rough, cut out and wouldn't go over 2000 rpm. At WOT it would actually slow a bit from a smaller throttle opening, say 1800rpm. No Check Engine light either. I switched it off, waited ten seconds or so, and restarted. The engine then ran fine and has been great since.

Now I know the solution here is not to do that anymore :) but I was just wondering if anyone else has ever run into anything like that, and if there was another solution in their case?
 
Back
Top