Now that I have the car and know more about it....

Jayls5

Registered User
I need a good estimate of the horsepower/torque output given the following mods:

Rebuilt engine, bored .040 over with new pistons. Just around 10k miles on it.
Intake
IC fan
5% overdriven supercharger
73mm MAF
70mm Throttle body
Flowmaster exhaust
3.07 gears with shift kit


Just a general estimate. The owner said it was around 300 hp at the crank.
 
i have a stock motor with 140,000 miles on it. the only mods that you have that i dont is the throttle body, i only have a 5% pulley, and my maf is 75mm. i dynoed at 200rwhp and 288 rwtq. but a 10% might be too much if you still have the stock ic, even with a fan so you might not get as much out of it.
 
Last edited:
specops_SC said:
i have a stock motor with 140,000 miles on it. the only mods that you have that i dont is the throttle body, i only have a 5% pulley, and my maf is 75mm. i dynoed at 200rwhp and 288 rwtq. but a 10% might be too much if you still have the stock ic, even with a fan so you might not get as much out of it.


hmm, that's not bad. You think the fact that my engine is brand new and has a tad more displacement will add some power?

I'm trying to get 250 whp eventually. What do you think the quickest way to achieve this is? Port the blower and get a better intercooler?
 
Back
Top