PDA

View Full Version : Search is down; Part Numbers needed



pastera
06-24-2002, 10:38 AM
I can't search back further than a month.

Does anyone have the part numbers for the following:

steel idler pulleys
Harmonic balancer
Harmonic balancer bolt and washer

All for a stock 89 Auto with the forged crank

Thanks

Aaron

joenintiesc
06-24-2002, 10:54 AM
I justed picked up some Dayco idler pullies yesterday. The p/n posted awhile back was 89007. But I got two of 89016 and one of 89007 - the 89016 is slightly wider (same diameter) so the belt rests fully on the pully- no ryme intended...

gldiii
06-24-2002, 11:02 AM
One month is about all the Tech posts go back!

Crank bolt F58Z-6A340-A '98 3.8L Mustang crank bolt (3-pack). SC part was discontinued.
Crank bolt washer E2DZ-6378-A '98 3.8L Mustang crank bolt washer (5-pack).
Most dealers will sell just one of each!

Tensioner pulley Ford F8KZ-8678-AA '98 Mustang Cobra 76mm Tensioner pulley (steel). These will replace all 3 SC pulleys. They original one on the supercharge is smaller diameter.
Tensioner pulley Motorcraft YS-233 '98 Mustang Cobra 76mm Tensioner pulley (steel). These will replace all 3 SC pulleys. They original one on the supercharger is smaller diameter.
Tensioner pulley Murray Climate Control O'Reilly's 45979
Tensioner pulley NAPA 209766
Tensioner pulley Factory Air 45979

Don't have the part # on the factory harmonic balancer. It is not that good anyway. BHJ makes a great aftermarket one for our cars. Info is here:

SCCoA BHJ Buy Post (http://209.15.55.25/forums/showthread.php?s=&threadid=5367)