PDA

View Full Version : Re-Programming Keyless Remote Transmitter



Bob Pringle
06-24-2002, 11:15 AM
I've found the instructions in the Helm manual for re-programming the keyless remote transmitter but I can't get past instruction #1. Specifically, I can't find the two-wire connector, J4, that must be shorted to begin the procedure. Can anyone find the connector in the photo below and point it out to me?

http://community.webshots.com/storage/1/v1/1/98/9/41619809rISdEz_ph.jpg

The format used to show the photo was:
"http://community.webshots.com/storage/1/v1/1/98/9/41619809rISdEz_ph.jpg"
without the "".

Thanks for any help!

Regards,
Bob P.

Bob Pringle
06-24-2002, 11:19 AM
That didn't work so well, did it? Let's try it again:

http://www.community.webshots.com/storage/1/v1/1/98/9/41619809rISdEz_ph.jpg

Bob Pringle
06-24-2002, 11:20 AM
Sorrry, guys. I guess we can't link directly to pictures in Webshots. You can view the picture by right-clicking the little red "X", clicking on "properties" and copying the picture's URL into the "Address" window in Internet Explorer.

MKTSC
06-24-2002, 11:39 AM
i too tried doing this. the 94-5 connector is behind the drivers side trim in the trunk (by the fuel pump shutoff) the erlier models are behind the glovebox. my problem is that once i jump the wires together, nothing happens. it sucks because i paid 50 bucks for my transmitter, and it doesnt work. :(