Re-Programming Keyless Remote Transmitter

Bob Pringle

Registered User
I've found the instructions in the Helm manual for re-programming the keyless remote transmitter but I can't get past instruction #1. Specifically, I can't find the two-wire connector, J4, that must be shorted to begin the procedure. Can anyone find the connector in the photo below and point it out to me?

41619809rISdEz_ph.jpg


The format used to show the photo was:
"
41619809rISdEz_ph.jpg
"
without the "".

Thanks for any help!

Regards,
Bob P.
 
Sorrry, guys. I guess we can't link directly to pictures in Webshots. You can view the picture by right-clicking the little red "X", clicking on "properties" and copying the picture's URL into the "Address" window in Internet Explorer.
 
Last edited:
i too tried doing this. the 94-5 connector is behind the drivers side trim in the trunk (by the fuel pump shutoff) the erlier models are behind the glovebox. my problem is that once i jump the wires together, nothing happens. it sucks because i paid 50 bucks for my transmitter, and it doesnt work. :(
 
Back
Top