OK, right now the SC has a Crane regrind cam with .509 lift, 3/4 top, mid-length headers, 2.25 dual exhaust and underdrive pullies. I belive my next mods will be either a 5% or 89-93 SC pulley and a double IC. I have no intake side, except a panel K&N, so which would be a better upgrade for "down the road", Pro-M 75mm Bullet or Pro-M 80mm. I think I can get a good deal on either one. The other mods were a too good to pass up deal, so on the went knowing that with out a MAF & TB, I would not get the full gains.
The Pro-M's have to be seen back to be calibrated correct, while the C&L use a tube?
Future plans besides a MAF will most likely only be a larger TB and if the AR take of and the "S" port or Magnum stuff prices falls, maybe an upgrade blower/plenum.
So what is everones $.02.
The Pro-M's have to be seen back to be calibrated correct, while the C&L use a tube?
Future plans besides a MAF will most likely only be a larger TB and if the AR take of and the "S" port or Magnum stuff prices falls, maybe an upgrade blower/plenum.
So what is everones $.02.