Lots of parts for sale

S

Screwloose

Registered User
Two Image dynamics IDQ 12" 4ohm DVC’s. $250obo for both of them.
Technical specs


Wiring
It's all lightning audio components. 16ft 6inches of blue 1/0 gauge, 17ft 7inches of silver 1/0 gauge, both are 1029 strand silver coated copper wire. The ring terminals, inline-fuse holder, battery post terminals, and main power connections to the fused and non-fused distribution blocks are compression fittings and are platinum plated. The caps are 1.0-farad 16V. There are 3 Maxi fuses in the fused distribution block, 2x80A, 1x50A, all three are platinum plated. The inline fuse holder has a gold plated 250A ANL fuse.
$350obo for all wiring.


Gfx off a 90 SC. $150
Includes metal mounting strips and plastic clips. Needs refinishing.

Rear bumper off a 90 SC. $150
Needs refinishing.

A rear set of springs off a 90 SC. $40obo

Rear sway bar off a 90 SC. $40obo

Two MN12 Rear hubs. $20obo each

Drivers side rear knuckle with hub and dust shield off a 90 SC, bearing needs replaced. $50obo

Rear calipers off a 90 SC, need rebuilt but would work well for cores. $30obo

I'll get some pictures added for some of this stuff next week.




Reasonable offers considered, no low balls or window shoppers. If you will not have the money for a month don't waste my time.
 
Here's some more info about the wiring stuff:

ring terminals- platinum plated with one thru-hole terminal and one 1/0ga compression terminal.

inline ANL fuse holder- platinum plated with 1/0ga compression terminal input and output.

battery post terminals- platinum plated with one 1/0ga compression terminal and two 4ga compression terminals

fused distribution block- platinum plated one 1/0ga compression input terminal, two 4ga compression input terminals, four 4ga outputs (wire held by set screw).

non-fused distribution block- platinum plated one 1/0ga compression input terminal, two 4ga compression input terminals, four 4ga outputs (wire held by set screw).
 
You must log in or register to reply here.
Back
Top