Screwloose
Registered User
I'm looking for a 3.08 or 3.27 T-loc rear end in new condition or low miles. Also looking for a starter, condition does not matter as long as it can be used for a core.
I have some parts to trade:
Two Image dynamics IDQ 12" 4ohm DVC’s. $250obo for both of them.
Technical specs
Wiring
It's all lightning audio components. 16ft 6inches of blue 1/0 gauge, 17ft 7inches of silver 1/0 gauge, both are 1029 strand silver coated copper wire. The ring terminals, inline-fuse holder, battery post terminals, and main power connections to the fused and non-fused distribution blocks are compression fittings and are platinum plated. The caps are 1.0-farad 16V. There are 3 Maxi fuses in the fused distribution block, 2x80A, 1x50A, all three are platinum plated. The inline fuse holder has a gold plated 250A ANL fuse.
$350obo for all wiring.
Gfx off a 90 SC. $150
Includes metal mounting strips and plastic clips. Needs refinishing.
Rear bumper off a 90 SC. $150
Needs refinishing.
A rear set of springs off a 90 SC. $40obo
Rear sway bar off a 90 SC. $40obo
Two MN12 Rear hubs. $20obo each
Drivers side rear knuckle with hub and dust shield off a 90 SC, bearing needs replaced. $50obo
Rear calipers off a 90 SC, need rebuilt but would work well for cores. $30obo
I have some parts to trade:
Two Image dynamics IDQ 12" 4ohm DVC’s. $250obo for both of them.
Technical specs
Wiring
It's all lightning audio components. 16ft 6inches of blue 1/0 gauge, 17ft 7inches of silver 1/0 gauge, both are 1029 strand silver coated copper wire. The ring terminals, inline-fuse holder, battery post terminals, and main power connections to the fused and non-fused distribution blocks are compression fittings and are platinum plated. The caps are 1.0-farad 16V. There are 3 Maxi fuses in the fused distribution block, 2x80A, 1x50A, all three are platinum plated. The inline fuse holder has a gold plated 250A ANL fuse.
$350obo for all wiring.
Gfx off a 90 SC. $150
Includes metal mounting strips and plastic clips. Needs refinishing.
Rear bumper off a 90 SC. $150
Needs refinishing.
A rear set of springs off a 90 SC. $40obo
Rear sway bar off a 90 SC. $40obo
Two MN12 Rear hubs. $20obo each
Drivers side rear knuckle with hub and dust shield off a 90 SC, bearing needs replaced. $50obo
Rear calipers off a 90 SC, need rebuilt but would work well for cores. $30obo