fastsc92
Registered User
I really wanted to run a 3.5" outlet resonator, however i ran into some set-backs. This is what I planned on running:
The case size is the same as what I was running and should fit. However, the case is 11" wide rather than 8" which is the standard res that people run.
I dont think I'll be able to fit it under the car since it'll have to hang much lower than the spot it should go into. So here is my question.
Do you think its ok to run this resonator:
and then just run an adapter to go into 3.5" dirrectly after the outlet? I really didn;t want to do that because internally its still 3" but I might be forced to go that route. I think the 24" case is a good length for the best sound, otherwise i;m stuck using a 14" case.
The case size is the same as what I was running and should fit. However, the case is 11" wide rather than 8" which is the standard res that people run.
I dont think I'll be able to fit it under the car since it'll have to hang much lower than the spot it should go into. So here is my question.
Do you think its ok to run this resonator:
and then just run an adapter to go into 3.5" dirrectly after the outlet? I really didn;t want to do that because internally its still 3" but I might be forced to go that route. I think the 24" case is a good length for the best sound, otherwise i;m stuck using a 14" case.