PDA

View Full Version : polishing parts



LostDreamer
01-13-2005, 03:49 PM
what isthe best way to polish my blower IC IC tube TB IB and Mafs im using a wire wheel and it works but its hard to get in some spots my dad said try a sand blaster but im not sure dont wanna spend too much money so how should do it?

blue94sc
01-15-2005, 05:17 PM
Hello.
I have been polishing my tensioners and have found that a Dremel works great. You may be able to get into the smaller areas with the Dremel wire wheel easier. I then go over it with polishing compound and a small buffing wheel.
Sandblasting it will only clean the surface but it will leave it pitted. The amount of work depends on how shiny you want the surface to be.
There are some other posts in the Detailing section that have some other good information..
Good luck!
Bill