J
jason gordon
Guest
Hi all. I'm new here. Have had my 91 SC for 2 years now and have been reading the forum for a while. I finaly had a head gasket go on me. So...while I have the heads off I was going to clean the chambers up and clean up the casting flash and machining ridges in the ports(intake /exh) and maybe build a set of custom headers and good exaust system after it. the car is stock except for a removed air silencer. Will i have to do anything else like larger injecters ect. After this I will probaby work on the intake side of things but I thought this was the best place to start. I realize after I do the intake mods I will have to go up to larger injectors and better fuel pump. But with just the exaust mods will I have to do anything? Also I was just wondering can an eaton be used in a draw through system(Wet) or will the fuel contaminate the bearings? Thanks for yor time.
Jay
Jay