MP Cold air divider question...

lrsudog

Registered User
I just installed my last mod, an MP cold air divider plate. No instruction came with it, which is fine.

But...

What the hell are the two, odd shaped, little pieces of sheet metal left over supposed to be for?
 
lrsudog said:
I just installed my last mod, an MP cold air divider plate. No instruction came with it, which is fine.

But...

What the hell are the two, odd shaped, little pieces of sheet metal left over supposed to be for?

It should look like this. I'm guessing the little pieces are the ones that goes around the MAF and under the coolant coolant recovery tank mounting tab.

neibert4.jpg


David
 
Well they sort of fit there. The angles are about right and the larger one does have a radiused slot that it perfect for the MAF/coolant tank loom, so that's where they are going to stay.

Thanks! Should be good for another 20 HP, right?
 
Back
Top