PDA

View Full Version : MP Cold air divider question...



lrsudog
01-28-2005, 11:04 PM
I just installed my last mod, an MP cold air divider plate. No instruction came with it, which is fine.

But...

What the hell are the two, odd shaped, little pieces of sheet metal left over supposed to be for?

David Neibert
01-28-2005, 11:26 PM
I just installed my last mod, an MP cold air divider plate. No instruction came with it, which is fine.

But...

What the hell are the two, odd shaped, little pieces of sheet metal left over supposed to be for?

It should look like this. I'm guessing the little pieces are the ones that goes around the MAF and under the coolant coolant recovery tank mounting tab.

http://www.sccoa.com/member/images/neibert4.jpg

David

lrsudog
01-28-2005, 11:55 PM
Well they sort of fit there. The angles are about right and the larger one does have a radiused slot that it perfect for the MAF/coolant tank loom, so that's where they are going to stay.

Thanks! Should be good for another 20 HP, right?

x182dan
01-29-2005, 12:01 AM
wrong post