PDA

View Full Version : Engine dies when I turn the steering wheel



Jim175
01-29-2005, 11:13 PM
Hey Guys,
I just finished doing a head gasket job, replaced the fuel pump, and filter, 2 new o2 sensors.
The damn thing dies when I turn the wheel.
Any Ideas, I did a search to no avail.
Thanks in advance,
Jim

Jim175
01-29-2005, 11:17 PM
Oh Yeah, I almost forgot.
Whilst cruisng at 25, accellerate at about 30% throttle, the engine has a nasty miss.
Thanks again,
Jim
90sc

J.D.
01-30-2005, 12:41 AM
At the bottom of the page, under "Similar Threads", is a thread titled "turn the wheel - rpms drop". It mentions the IAC. Did you by chance remove the IAC while changing the head gaskets?
It looks like a load on the engine (power steering, acceleration) is causing it to miss or die. What happens when you turn on the A/C?

Jim175
01-30-2005, 01:03 AM
Hey J.D.,
Thanks for the response.
The A/C system is not charged right now, but I did see the links at the bottom of the page after the fact. I went ahead and ordered a new ISC(Its never been replaced since I have had the car), and TPS(likewise) Hopefully those will cure the problems. Other than that, there is the miss under accelleration, which I hope a new set of plugs and wires will cure.
Jim

rlong
11-10-2005, 12:39 AM
if you just put it together it may take a few days to learn to idle right but for the miss it may be a plug or wire

JimmyDean
11-10-2005, 01:26 AM
How are your motor mounts?

xThunderbirdSCx
11-10-2005, 10:18 AM
your gravedigger....this post is almost 11 months old

JimmyDean
11-10-2005, 05:03 PM
Holy cow I should have checked that. It was on the front page... rlong resurrected!