I'm looking at the diagram that shows how to ground the #4? pin connector on the Pressure Switch electical connector. (Not on the switch itself, but the wire harness going to it)? If I do this, AND the pump runs, then the pressure switch is bad and not the relay because the Pressure Switch tells the relay when to turn on power to the pump.
Does any one have a pic of the actual harness that I need to ground?
After reading and reading some more went ahead and posted the most asked for pics for the abs system from other members threads. I think it might help other members with the same problem.
Does any one have a pic of the actual harness that I need to ground?
After reading and reading some more went ahead and posted the most asked for pics for the abs system from other members threads. I think it might help other members with the same problem.
Attachments
Last edited: