CMac89
Registered User
I ported my inlet plenum and the inlet on my blower on saturday with a dremel tool. I was porting it on the inlet side and i dremeled a hole in it on accident about the size of a penny right by bolt hole. I tried epoxying it shut twice and the blower just sucked it in even after letting it dry overnight.
It will run but it will not idle at all, you just have to keep giving it gas. Vacuum is about 7. Will this hole make you lose power at all? It has about 16psi even with the vacuum leak. I raced some guys today that i normally beat and i got beat by them so i suspect i am losing some performance from the hole.
Any feedback would be appreciated.
thanks
It will run but it will not idle at all, you just have to keep giving it gas. Vacuum is about 7. Will this hole make you lose power at all? It has about 16psi even with the vacuum leak. I raced some guys today that i normally beat and i got beat by them so i suspect i am losing some performance from the hole.
Any feedback would be appreciated.
thanks