FastBird91
Registered User
A couple days ago i replaced my power steering pump because i was not getting any assist from it. My new pump works great but it leaks, and the variable assist seems to not be working. Whether i have it on firm or not it seems to be the same. It does not firm up when i put it in firm mode or when i am at high speeds. It appears to be leaking right where the high pressure hose hooks up on the pump. I have just read some threads and see that i should of put some new teflon tape on the threads and even replaced the o-rings on the valve. I am going to do so very soon but my question is, can this be the cause of the firmness to not be stiffining up like it should? I know where the valve goes into the pump i put the spring in the pump first then the valve then screwed on the high pressure hose. Is this correct?
Thanks again
Thanks again