SC's & AOD's

SilverFox

Registered User
True / False

SC AOD's came with:
1)"A" Overdrive servo's
2) 7 spline output shafts (aka they can use 23 tooth speedo gear)
3) use short output shaft and tailhousing just like Mustang
 
SilverFox said:
True / False

SC AOD's came with:
1)"A" Overdrive servo's
2) 7 spline output shafts (aka they can use 23 tooth speedo gear)
3) use short output shaft and tailhousing just like Mustang

1) True
2) Don't Know
3) True (I think, I do know that the output shaft is about an inch shorter than the truck output shaft. I'm assuming it's the same as the Mustang)
 
I had better response on Corral and FvC than you guys and you use the trannies everyday! i know you can do better than this.
 
SilverFox said:
I had better response on Corral and FvC than you guys and you use the trannies everyday! i know you can do better than this.
I think thats the key.. I use the tranny everyday, but I don't swap it out very often. :rolleyes: I'll measure the tail housing later if you wish.. As for the output shaft, if you are talking about the tail portion which the driveshaft slips over, there are more than 7 splines. More like 20-something. :) I'm not surprised about corral, keep in mind there are about 100x more Mustangs on the road than supercoupes and they have a huge following. :rolleyes:
 
SilverFox said:
I had better response on Corral and FvC than you guys and you use the trannies everyday! i know you can do better than this.
So if you had better responses, would you might sharing the answers you found?
 
Back
Top