ScrapSC
Registered User
Alright here it goes. I have read on here about a couple ideas on this and have seen where the entire bearing and jackshaft have to be pressed out as one unit. At this point and time is there a replacement bearing that works? I have a press and can press it out but just wanting to check on the steps of doing this. Anyone done this lately??
I have a couple extra jackshafts, or at least I think I do... Just wanting to see if pressing this one out and replacing the bearing was possible..
I have a couple extra jackshafts, or at least I think I do... Just wanting to see if pressing this one out and replacing the bearing was possible..