valve cover job

rzibilske77

Registered User
I an in need of a new gasket(valve cover) on the passenger side on my 35th.
on a scale from 1 to 10 for an averge joe..whats the difficulty?
what has to be removed to get it done & should i just try to tighten first.

Robert
 
rzibilske77 said:
I an in need of a new gasket(valve cover) on the passenger side on my 35th.
on a scale from 1 to 10 for an averge joe..whats the difficulty?
what has to be removed to get it done & should i just try to tighten first.

Robert

I couldn't tell the difficulty, but I can tell you that mine was leaking, and I tightened it up (the bolts got real loose :confused: ). Never had a problem after that.
 
91_SC_BIRD said:
I couldn't tell the difficulty, but I can tell you that mine was leaking, and I tightened it up (the bolts got real loose :confused: ). Never had a problem after that.

I did the same thing 1 1/2 years ago and 18,000 miles. It hasn't caused me any trouble since.

I needed to remove the throttle body to get to the rear bolts. If you have a 1/4 socket set with extensions and deep sockets. Tightening it I would rate that at a 4. I was the very first thing I ever did to my SC and that was before I found this site.
 
Back
Top