scbird1
Registered User
Well I found out my low speed fan was not working so I took it apart. That was the hard part is you need to cut the crimped ends of the metal. What I found was 2 of the brushes had worn out so im going to clean up the armature with 1000 grit sand paper and solder in some new brushes on the low speed side. Im sure I can get them from a electric motor repair store.
I have never seen anything like this thing and I can see why you dont want to have both running at the same time. Check out the pic`s
One word of caution, dont try to remove the fan blade. They tend to rust to the shaft and dont like to come apart.
I have never seen anything like this thing and I can see why you dont want to have both running at the same time. Check out the pic`s
One word of caution, dont try to remove the fan blade. They tend to rust to the shaft and dont like to come apart.
Attachments
Last edited: