PDA

View Full Version : stalling when wheel is turned



Lvcien
05-08-2005, 02:10 PM
I started it up, I had just added some p/s fluid -- and I was in park and began to turn the wheels to get the fluid moving into the pump, as I did my idle began to get low 500'ish and then go back up to 700'ish and I kept turning it and eventually it stalled out -- is this because of my vaccuum leak? I still need another nut to seal the ic tubes... and some more RTV :D

quick35th
05-08-2005, 07:04 PM
Well having zero vac leaks is always a good thing, but if when you fix the vac leak and it still stalls out when the wheel is turned then I would say you have a failing ps pump. Good luck!

Shane

blackout50
05-08-2005, 07:42 PM
Poss the pressure swith.It should be on the pressure line.

ARV90SC
05-08-2005, 08:54 PM
engine mounts? i remember mine stalled on me before i had mine changed, in the same situation

LightEMup
05-08-2005, 09:58 PM
mine doesn't stall out, but it sure does draw off the engine, drops the rpm's way down. i usually give it a little gas when i'm turning the wheel at a dead stop