3 angle valve job.

Darkside

Registered User
I was going to do my valves and was planning on doing a three angle job. I was planning on doing 45, 15, and 60 degree cuts. Is this going to work out for me. I'm not sure of the best specs as I've never done a set of automotive cylinder head valves before. The 45, 15, and 60 degree cuts are the ones we use on aircraft cylinder valve seats. Any opinions.
 
Darkside said:
I was going to do my valves and was planning on doing a three angle job. I was planning on doing 45, 15, and 60 degree cuts. Is this going to work out for me. I'm not sure of the best specs as I've never done a set of automotive cylinder head valves before. The 45, 15, and 60 degree cuts are the ones we use on aircraft cylinder valve seats. Any opinions.
Anybody have an opinion? :confused:
 
Back
Top