PDA

View Full Version : 3 angle valve job.



Darkside
06-18-2005, 11:23 AM
I was going to do my valves and was planning on doing a three angle job. I was planning on doing 45, 15, and 60 degree cuts. Is this going to work out for me. I'm not sure of the best specs as I've never done a set of automotive cylinder head valves before. The 45, 15, and 60 degree cuts are the ones we use on aircraft cylinder valve seats. Any opinions.

Darkside
06-21-2005, 05:57 PM
I was going to do my valves and was planning on doing a three angle job. I was planning on doing 45, 15, and 60 degree cuts. Is this going to work out for me. I'm not sure of the best specs as I've never done a set of automotive cylinder head valves before. The 45, 15, and 60 degree cuts are the ones we use on aircraft cylinder valve seats. Any opinions.
Anybody have an opinion? :confused:

Jeremy_K
06-21-2005, 11:06 PM
Bring em' over. I'll hit them with the dremel! Any angle you want. :p