PDA

View Full Version : sc nut for oil striped



scbirdrollout
06-22-2005, 09:47 AM
well guy i am in hard spoy hear my hex nut fot the sc wher u ut the sc oil is strit out i have no idear on how to trmove it what u all think ,,,,,,,,,,,,need help thanks guys..........

David Neibert
06-22-2005, 11:01 AM
It's 3/16" countersunk allen type connection. If you can't get a wrench in the hole you may be able to get a screwdriver tip in tight enough to loosen it. The replacement plug is a standard hardware item (7/16" SAE countersunk plug with oring).

Sears and a couple places also sell bolt extractors for when you strip them out. If you have access to a welder, a small bolt can be welded to the top of the plug.

David

HSKR
06-22-2005, 03:00 PM
well guy i am in hard spoy hear my hex nut fot the sc wher u ut the sc oil is strit out i have no idear on how to trmove it what u all think ,,,,,,,,,,,,need help thanks guys..........

I was able to take a flat blade screwdriver that was slightly wider than the hole and pound it in witha hammer and get the plug out that way. Still use the same trick because I'm too cheap to just buy a new plug.