cam sensor

If you're just installing the cam sensor cap, you shouldn't need anything special (maybe a tamperproof torx bit for the two screws that attach it). If you're installing the entire cam sensor assembly, you should use a Ford tool specifically designed for aligning the sensor correctly.

-Rod
 
Its called a 5.5m socket. Or might be 6.5mm. That's all you need unless you did something to disturb the setting such as pulling the cam shaft out. :)
 
racecougar said:
If you're just installing the cam sensor cap, you shouldn't need anything special (maybe a tamperproof torx bit for the two screws that attach it). If you're installing the entire cam sensor assembly, you should use a Ford tool specifically designed for aligning the sensor correctly.

-Rod[/QUOTE

Where can i get that Ford tool?
 
If you are replacing just the cam sensor, just get a 5.5m socket. Works great...you cannot screw it up. Just take the 2 bolts out, put the new cam sensor on, you are good to go.

Stephen
 
Back
Top