J
Joisey Jim
Guest
I have an idea for restoring engine mounts without replacing them with new solid ones, as follows:-
Jack- up the motor a little and providing the mounts haven't collapsed, cracked or separated drill a small hole in the center where the liquid/gel compartment is and fill with expandable foam from a can - like the ones sold at hardware stores for sealing cracks, etc.
Anyone have any thoughts on this idea?
Jack- up the motor a little and providing the mounts haven't collapsed, cracked or separated drill a small hole in the center where the liquid/gel compartment is and fill with expandable foam from a can - like the ones sold at hardware stores for sealing cracks, etc.
Anyone have any thoughts on this idea?