PDA

View Full Version : Light for Keyless entry out...



bksho
10-13-2005, 10:51 AM
But the Key light Still works? how do i fix this.

J.D.
10-13-2005, 01:19 PM
If you mean the illumination for the keypad above the door handle, the LEDs have most probably burnt out, which means you'll have to find a new keypad. If you want to be sure before buying a replacement, then check the light blue wire (power to the LEDs) and the black wire (ground) in the keypad harness. The keyhole light works off a different circuit.

bksho
10-13-2005, 02:17 PM
then check the light blue wire (power to the LEDs) and the black wire (ground) in the keypad harness. The keyhole light works off a different circuit.

So pull the Keypad harness out check wires make sure they are all connected ect. Do you recall what circuit the keypad is on?

J.D.
10-13-2005, 04:14 PM
Power to the LEDs is supplied directly from the keyless entry module. If the keypad buttons work (open/lock the doors) you don't need to check for a burnt fuse. You can verify that the module is suppplying voltage to the keypad LEDs by checking for voltage at the light blue wire to the module. You can verify that the wiring between the module and the door is good by checking the voltage between the light blue and the black wires at the connector behind the door panel.