running wires for a fan switch

me too

i had the same problem.....i couldn't find where to run them through the firewall. Someone told me to run it steering shaft boot. I took a coat hanger and poked it through the rubber. Then pulled the wires through with it again.....worked good. Seals out any dirt or moisture. I then ran the wires into the console...under everything and put a small switch inside....on the side...so no one knows its there but me. good luck!
 
I drilled a hole and used a rubber throttle cable grommet

fits tight dont leak you can get at most auto parts stores about $1
 
Drill a big hole and use a plastic or rubber trunk plug so future wires can come through your fire wall on drivers side. First set on mine alarm wires, then trans temp sender wire, then cooling fan switch wire. this way it is easy to add wires on future mods without having ten different holes in your firewall



EddiE 92 coupe:cool:
 
Back
Top