91 clutch line for 90

90coug

Registered User
Before I knew better I purchased a 91 XR7 clutch line for a 90 XR7. I've already installed it and it seems to work fine. I have a small drip under the car right at the bell housing\engine and the clutch is acting up, I'm thinking the slave cylinder has taken a dump which had been replaced along with the rest of the clutch. The flywheel needed to be machined and it was bad when I gave it to him.

Should I have shimmied the slave cylinder, could this be why it failed? Wrong clutch line or maybe just a crappy slave cylinder to begin with?
 
Last edited:
They might not, I do remember asking for a 91 instead of a 90, besides that does anyone have any input?
 
Back
Top