Dyno day with Dave!

I also hit the dyno today with Dave Dalke. He installed the chip in my car. These are the best 2 pulls out of 7 today.
248.4 HP
341.1 LBS/FT TRQ
Pretty good for a mildly modded 1st gen SC i think.

Not bad numbers.

What are your full mods?

Engine Modifications:
K&N Air Filter with custom intake tube
73mm C&L MAF
10% No Slip OD Pulley by Spinning Wheels SC
8" 2100 cfm Intercooler Fan
Heads Ported by Super Coupes Unlimited
Port Matched Intake by Super Coupes Unlimited
Unshrouded Valves
Custom Engine Bay paint job done by me.
Custom Chip by Super Coupes Unlimited
Full Borla Cat Back Exhaust (Resonator and 2 mufflers and chrome tips out the back. Pic is before installation)
Engine Mounts

Drivetrain Modifications:
B&M Ripper Shifter
Transmission Mounts

Suspension Modifications:
1.25" lowering Tokico Springs
New Tokico Illumina 2 Shocks
New upper control arms and balljoints
New lower control arms and balljoints
New Tie Rods

Are you using the early or late model blower? Stock cam also?

Stock cam. Stock 89 blower.